Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Not able to get can protocol output from can fd engine

Status
Not open for further replies.
Joined
Jun 8, 2018
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
19
I am trying to get communication output for CAN protocol. I am using CAN Engine MCP2518FD and CAN Trans-receiver as ATA6561. I couldn't been able to get the output. I have done many projects successfully using CAN protocol but previously I have used CAN Engine MCP2515 and MCP2551 as trans-receiver. I am not able to find out whether I am missing something out in the design part or elsewhere. I am using CAN 2.0 only but this CAN Engine MCP2518FD also support CAN FD. I am attaching my schematics also. Please point out any faults or give me some of yours valuable thoughts over where I am doing mistake. Thank You.
 

Attachments

  • CAN_verification.pdf
    42.4 KB · Views: 99
Last edited:

Hi,

I recommend to use a scope to verify the signals.

Klaus
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top