Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Need help about this OP AMP Configuration

Status
Not open for further replies.
The simulation shows that the red branch suggested in post #17 isn't completely irrelevant, it causes the usually unwanted filter leakage above 10 kHz. It's a disadvantage of the Sallen-Key topology, other topologies have non-bypassed shunt capacitors and respectively less high frequency leakage.

It should be also mentioned that the chosen C1/C2 and C3/C4 capacitor ratio doesn't result in effective low pass filter with sharp cut-off frequency. But as we heard, the values are only guessed, apparently not so well.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top