Rosalinekavitha
Member level 1
Hi, i am trying to compute power transfer efficiency between coils using HFSS. When the Rxer coil sweeps coaxially (manual operation), i found the port is detached from terminals. In parametric set-up i have defined the coaxial sweep of coil between 10mm to 20mm. But for all values of sweep,there is no change in the value of mutual inductance.
Also a warning of "A variation (z_sp='12mm') has been requested on machine Local Machine" was thrown for all values of sweep.
Port is defined using rectangular sheet alone. [But i have tried wrap,imprint n creating polyine]. How to fix the port permanently for all values of sweep?
Also a warning of "A variation (z_sp='12mm') has been requested on machine Local Machine" was thrown for all values of sweep.
Port is defined using rectangular sheet alone. [But i have tried wrap,imprint n creating polyine]. How to fix the port permanently for all values of sweep?