Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Relay Selection to START and STOP the Motor-Pump operated starter

Status
Not open for further replies.

saramah

Member level 3
Joined
Apr 25, 2018
Messages
64
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
689
Hi,
I want to use pcb relay to control(on/off) the submersible motor-pump of 5 hp with MCU control.

for that, efficiency = 85%, pf=80%, at 230v, the Continuous current(I) will be,

Input=o/p / efficieny = 5/0.85 = 5.8 ==6 hp x 746 =4.476 kw.

I= 4.476/(230x0.8) = 25A running current.

--As the starting Amp of an Induction motor are 3 to 5 times the running current/Full load current FLA.

--So need Power relay which will withstand for such starting Amp (ie 25A x 5 = 125 Amp).

IS the relay model "JQX-15F (T90)" is sufficient to withstand and longer life. The datasheet is also attached here.
From the data sheet,
I=30A, Contact materials is AgCdo used. But the withstand current not found here in the datasheet.

Please suggest ,
How do i calculate/find the withstand current for that amount of starting current from this datashhet??
Is my all above calculation correct ?
 

Attachments

  • JQX-15F(T90).pdf
    109.3 KB · Views: 77

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top