neazoi
Advanced Member level 6
Hi, in this schematic (attached) what is the output signal level of the AD9851? Is it -5dBm? I need to verify if I am reading the datasheet correctly, that is why I am asking.
Also, to measure the power level on a scope (at 50R), should I use the high impedance probe, since there is a 50R shunt in the output of the circuit?
Thank you
Also, to measure the power level on a scope (at 50R), should I use the high impedance probe, since there is a 50R shunt in the output of the circuit?
Thank you
Attachments
Last edited: