Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Description of telemetry transmitter

Status
Not open for further replies.

senmeis

Full Member level 3
Joined
Nov 26, 2014
Messages
159
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,465
Hi,

the following statement is taken from the telemetry standard IRIG Standard 106-11:

The RF signal is typically generated by filtering the baseband non-return-to-zero-level (NRZ-L) signal and then frequency modulating a voltage-controlled oscillator (VCO). The optimum peak deviation is 0.35 times the bit rate and a good choice for a premodulation filter is a multi-pole linear phase filter with bandwidth equal to 0.7 times the bit rate.

Could anyone explain what “optimum peak deviation” means? Is it a parameter of filter? Are such constraints difficult to achieve?

Senmeis
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top