Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What wire is this? Old 2009 TV

Status
Not open for further replies.

rjd2

Newbie level 1
Joined
Nov 20, 2019
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
10
I went to my familys house and they had an issue with their speakers. It turns out the audio cable broke, though I looked at the TV and this is it:
wxL7ysN.jpg


it's a 2009 TV, and I'm guessing Made in China VGA or 2.5mm wires.
 

Figure of 8 twin cable fitted with 4mm plugs.

You can use twin power cord wire to replace the cable and the plugs are cheap and easy to find.

Brian.
 

Do you suspect a broken wire inside a connector? Try to unscrew the barrels on the plugs (called banana plugs in the USA). A broken wire could be gripped in a strain-relief, hence it doesn't necessarily come loose.

Cut away insulation to expose about 3/16 inch of bare wire end. Solder it back.
 

They are not usual cables for the speaker. They are commonly audio signal cables. If the cables are at fault, they must be broken (discontinuous) inside- just check with a multimeter.

They are cheap and easily available. It may be simpler to replace than to repair the connector. The connectors appear to be moulded in place.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top