NikosTS
Advanced Member level 4
Hello all,
I have saved in a table the response of a filter. The table contains 2 columns; the first contains the frequency and the second the corresponding magnitude.
I am building a model that will instantly "read" the value of the frequency during an AC analysis and using that value will find the corresponding magnitude through the table.
My thought was using something like $table_model( $freq, "table_link.dat") and assigning that value to the output, but it doesnt seem to work. Actually it seems like the only value of frequency is 0Hz.
Any ideas?
Thank you in advance
I have saved in a table the response of a filter. The table contains 2 columns; the first contains the frequency and the second the corresponding magnitude.
I am building a model that will instantly "read" the value of the frequency during an AC analysis and using that value will find the corresponding magnitude through the table.
My thought was using something like $table_model( $freq, "table_link.dat") and assigning that value to the output, but it doesnt seem to work. Actually it seems like the only value of frequency is 0Hz.
Any ideas?
Thank you in advance