Nighty123
Newbie level 5
Hello,
The following rectifier is working on 2.4GHz band with input power equal to 60mW which is approx equal to 17.5 dbm.
the results and schematic are attached below.
My question is :
How can enhance the circuit so i can make it give the same result or close to it with lower input power as example (-10 to 0) dbm ?
My project is to turn on a led with the following ( 1.9v - 20mA - 105 ohm) by using RF Energy Harvesting (Rectenna) on 2.4GHz band
is this possible ? if yes what should i do ? if not is there any advices?
Thanks in advance.
The following rectifier is working on 2.4GHz band with input power equal to 60mW which is approx equal to 17.5 dbm.
the results and schematic are attached below.
My question is :
How can enhance the circuit so i can make it give the same result or close to it with lower input power as example (-10 to 0) dbm ?
My project is to turn on a led with the following ( 1.9v - 20mA - 105 ohm) by using RF Energy Harvesting (Rectenna) on 2.4GHz band
is this possible ? if yes what should i do ? if not is there any advices?
Thanks in advance.