Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

interleved active clamp flyback converter circuit

Status
Not open for further replies.
A

Ashvinpambhar

Newbie level 5
Joined
Nov 17, 2019
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
99
In this circuit MOSFET is used as a switching device, if I want to generate waveform like fullwave rectifier output, then which type of pwm signal provides to MOSFET drive circuit.
 

usually, a full wave rectifier would supply the input bus voltage needed by the interleaved active clamp flyback.
You cant make a full wave rectifier with an interleaved active clamp flyback
 
as per the figure we provides a dc voltage as a input to the interleaved active clamp flyback converter block, provide a PWM signal to the MOSFET which is in interleaved block for switching purpose. PWM signal is generated by the microcontroller which has a fix frequency 57 KHz and 50 % duty cycle then we got a output like triangular waveform. actually we will need a output like a given figure so which type of PWM output will be provided to the switching MOSFET, so we got proper output of the interleaved active clamp flyback converter.
img_20191118_174027.jpg
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top