Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[ARM] VGA output using a STM32F103C8

Status
Not open for further replies.

Foster08

Newbie level 1
Joined
Nov 13, 2019
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
Hello all! First of all, I want to apologize for my poor English. I'm from Russia.

I have STM32F103C8 boad and I am trying to compile a project from this article https://www.artekit.eu/vga-output-using-a-36-pin-stm32/ (source code https://www.artekit.eu/resources/blog/artekit_vga. zip) in the Atollic TrueSTUDIO for STM32 9.2.0 environment, but when I try to compile this project, I get different errors every time. I'm new, and I donÂ’t know Keil, I only know a little TrueSTUDIO. How to adapt this project for TrueSTUDIO? Please watch my video, it shows all errors when trying to compile:
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top