Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

TL866II+ programmer and flash memory SST39VF040-70

Status
Not open for further replies.

Gregory007

Newbie level 1
Joined
Nov 13, 2019
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
14
Hello, I am new here and would like to greet all forum users first, :)

I have several questions probably due to lack of knowledge and experience.

1. IC1: cFeon EN29LV040A is the equivalent for IC2: SST39VF040-70? I have content written down from IC1 and I would like to write it on IC2. The saving process goes up to ca 50% and programming is stopped:

screenshot_122.jpg

2. Does the option "Fill" to any values or only FF? When trying to write other than FF, an error pops up, but partial attempts to write from the address range are OK, e.g. in the address range 0000-0000 to 0000-00FF only 4 lines can be filled in (ASCII "a", the next ones must be from 0100, because the above-mentioned error occurs.

screenshot_123.jpg

screenshot_124.jpg

3. Whether we use replacements for flash memory, or is this a last resort?

Thanks for the help in advance
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top