Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] type 1 compensation in voltage regulators

Status
Not open for further replies.

tenso

Advanced Member level 4
Joined
Feb 18, 2015
Messages
110
Helped
3
Reputation
6
Reaction score
2
Trophy points
1,298
Activity points
2,399
So I was reading an app note from Microsemi and came across a schematic for type 1 compensation using an opamp RC integrator.

Capture.PNG

So I wanted to know if this arrangement is right. Wouldn't you need a DC feedback resistor between the output and input to provide a DC path and regulate the DC voltage at the output? Or is it ok to not have a feedback resistor if the integrator itself is a part of the feedback loop?
 

Correct. The compensator is a part of the total system that includes DC feedback.
 
  • Like
Reactions: tenso

    tenso

    Points: 2
    Helpful Answer Positive Rating
The capacitor in feedback path offers infinite impedance at DC. That means you have Infinite Gain (Gain = - Zfb/Zin) at DC. In order to limit this DC gain you need a parallel resistor with capacitor.
Otherwise The DC gain will be limited only by the leakage impedance of the circuit.
 
Thanks for the help guys. question is answered, thread can be put as solved.
 

Hi,

thread can be put as solved.
Then do so....just by pressing the "Mark as solved" button below.

Klaus
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top