Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

A hole for Plastic pin of ethernet connector

Status
Not open for further replies.

baby_2

Advanced Member level 4
Joined
Jul 20, 2016
Messages
105
Helped
2
Reputation
4
Reaction score
1
Trophy points
18
Activity points
873
Hello,
Here the ethernet connector(http://www.kosmodrom.com.ua/pdf/HR911105A.pdf) that I am going to implement in Altium.

I need to know that for plastic connector (phi=3.25) if my configuration is right. (hole size=3.25 , X/Y for round shape=2.5)

20.PNG

25.PNG
 

No. You'll use non-plated hole for mechanical alignment or locking pins, without annual ring etc.
 

Thank you for your response. It means just by adjusting the hole size and disabling plated option ( even annual ring=0?) it works fine?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top