Rosalinekavitha
Member level 1
Hi,
i am trying to simulate the mutual inductance of 3D spiral coils for wireless power transfer application. While simulating the coil terminals with lumped port following warning occurs
also not getting a defined output plot. How to give a fix to this issue?
i am trying to simulate the mutual inductance of 3D spiral coils for wireless power transfer application. While simulating the coil terminals with lumped port following warning occurs
"User Defined Primitive: End edge position:
User Defined Primitive: Point0: x = 10.2109956554404, y = 0.00127102124808265, z = 0.5
Adaptive solution setup, process hf3d: '1' conductors touch lumped port '1', typically a lumped port contains 2 conductors. Please verify conducting boundaries and objects are correctly assigned and touch the port. If a Radiation boundary touches the port and it is desired for use during the port solution, select 'Use Radiation Boundary on Ports' under the Advanced tab in the Solution Setup."
also not getting a defined output plot. How to give a fix to this issue?