Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Reflections when conjugately matched

Status
Not open for further replies.

circuitking

Full Member level 5
Joined
Jan 8, 2018
Messages
291
Helped
1
Reputation
2
Reaction score
1
Trophy points
18
Activity points
2,503
Hi, as per Pozar's Microwave Engineering book, there is a condition
"A special case of the transducer power gain occurs when both the input and output are matched for zero reflection (in contrast to conjugate matching). Then GammaL = GammaS = 0" then GT=S21^2.
And another one is conjugate matched condition.
Does this mean ever after performing conjugate matching, there will be still reflections?. Could someone explain the difference between these two conditions.

Thanks in advance.
 

Last edited:
Hi, as per Pozar's Microwave Engineering book, there is a condition
"A special case of the transducer power gain occurs when both the input and output are matched for zero reflection (in contrast to conjugate matching). Then GammaL = GammaS = 0" then GT=S21^2.
And another one is conjugate matched condition.
Does this mean ever after performing conjugate matching, there will be still reflections?. Could someone explain the difference between these two conditions.

Thanks in advance.
There's a subtle distinction between travelling waves (aka voltage waves) and power waves. For travelling waves, the reflection coefficient is defined as Gamma=(ZL-Zs)/(ZL+Zs). For power waves, Gamma=(ZL-Zs*)/(ZL+Zs). So for a conjugate match, the power wave reflection coefficient will be zero, but the travelling wave reflection might not be.
 
Researched in my literature and found very intuitive explanation about Power Waves and Scattering
"Microwave Transistor Amplifiers-Analysis and Design"-Guillermo Gonzalez Section 1.7 pp:45-60
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top