Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

MBIST DONE & GO failing conditions

Status
Not open for further replies.

vipul982

Junior Member level 3
Joined
Feb 2, 2010
Messages
30
Helped
0
Reputation
0
Reaction score
2
Trophy points
1,288
Location
India
Activity points
1,465
Hi,

I want to assess the following condition:
If an MBIST controller and memory is intended to run at a functional frequency say 100MHz and a testbench is also generated to run at same frequency, but the frequency that is recieved is 20MHz. How will the failure look like in simulation?
1. will there be a DONE failure indicating a test did not complete?
2. Will the test run and indicate a DONE & GO failure?

Thanks,
Vip
 

1. DONE signal : Test time not enough. GO bit will not compare.
2. GO/GO_ID signal :Should the failure on the controller / mem_inf.

Tiep Ngo
 

i think the bset way is to do simulation on your design to check the result rrather than guess
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top