Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Is there any difference in registers of zigbee S2 pro and zigbee S2C module?

Status
Not open for further replies.

anshumantech

Newbie level 3
Joined
Aug 17, 2018
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
36
We have been using X’bee pro S2 module for last 5-6 years, now it’s not available, instead we have to use its replacement X’bee S2C. Our existing embedded S/W has stopped recognizing ‘End device’ which we configure using X-ctu software from PC as end device & co-ordinator which is successful, but in changed scenario both modules are recognized by respective embedded s/w as co-ordinator & hence keep scanning for end devices interminably.
Pl. suggest which registers inside module IC, which bits have been modified/differ between two modules S2 & S2C so that we can correct the anomaly. You must be knowing something about IC in detail, don’t worry about our embedded s/w, we will correct it based on your info.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top