Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Brushed DC micro motors with a nominal power of e.g 0.5 W can run at a small percentage of this power, e.g. 10 mW. Brushless DC and AC motors have lower friction and can potentially run at lower power.
The question is however, what do you want to drive with this low power? Mechanical power is respectively small.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
