Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Suitable SolderBall size selection

Status
Not open for further replies.
J

Javid.zare.s

Guest
Hi guys, I was wondering that is there a standard for solder joint size of BGA chips or mostly your stencil defines it for you?
for example what's the preferred solder ball size for 0.2*0.2 pad of a BGA chip?I ordered 0.3mm since it was their smallest available solderBall
tmp-cam-1184433650.jpg
 
Last edited:

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top