Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What is the size of terminal connector

Status
Not open for further replies.
As depicted on datasheet, pin dimensions are 0.5x0.9mm, whereas the recommended hole diameter (in fact not so clear) is 1.1mm.
 
  • Like
Reactions: Fan174

    F

    Fan174

    Points: 2
    Helpful Answer Positive Rating
andre_teprom said:
As depicted on datasheet, pin dimensions are 0.5x0.9mm, whereas the recommended hole diameter (in fact not so clear) is 1.1mm.
Click to expand...

Okay so when I click on the symbol I get property window. Where to set hole diameter in window
 

Attachments

  • Ponix connector.jpg
    Ponix connector.jpg
    60.8 KB · Views: 152

The above snapshot refers to the positioning properties of the component (apparently on schematic viewer), does not get into the component details. To do so, you must edit it in the library editor.

By the way, doesn't it seem obvious to you that it would be useful to mention what CAD you are using?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top