Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Errors occurred after setting up calibre view

Status
Not open for further replies.

hitjj

Newbie level 2
Joined
Oct 23, 2019
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
Dear all,

I have done DRC and LVS verification,
and after RC extraction(LPE), i wanna setup Calibre View,
but encountered lots of ERRORs.

error.JPG

How did these errors happen?
And how to solve these errors?
Thank you all.:bang:
 

Looks like a problem caused by the syntax - by the angular brackets.
Try replacing them by square brackets.
Different tools have different requirements on brackets (e.g. triangular vs square), and there may be some incompatibility there.
Sounds crazy (why would not they fixed such issues, over all these decades), but this is a fact of life.

Maybe because of this, instance pins are recognized as nets.
 
  • Like
Reactions: hitjj

    hitjj

    Points: 2
    Helpful Answer Positive Rating
Although there are lots of errors but the Calibre-view is still generated and i can run the post-sim normally.
Thank you very much, your reply is helpful for me!
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top