+ Post New Thread
Results 1 to 3 of 3

20th October 2019, 02:51 #1
 Join Date
 Sep 2018
 Posts
 26
 Helped
 1 / 1
 Points
 342
 Level
 3
Understanding of noise figure
Hi,
From the equation of cascade noise figure, we can see that the noise figure of the chain is determined by the first several stages of LNA. But how to physically understand it? Why is cascade noise figure set up bu the first several stages?

Advertisement

20th October 2019, 16:53 #2
 Join Date
 Oct 2001
 Posts
 4,858
 Helped
 1445 / 1445
 Points
 34,050
 Level
 45
Re: Understanding of noise figure
F(total) = F1 + (F2 – 1)/G1
where:
F(total) = Total noise factor
F = Noise factor of each stage
Noise Figure (dB) = 10*LOG(F)
G = Gain of each stage (linear not in dB)
From the two stage amplifier example below we can see that the first amplifier in the chain has the most contribution on the total noise figure. For this reason the lowest noise figure amplifier, always should be placed first in a line of amplifiers.
Also, from the equation of the noise factor we can see that the gain of the 2nd amplifier doesn’t have any contribution on the total noise figure, but the gain of the first stage (G1) does have an impact.
A rule of thumb is that the first stage to have a gain greater than 10dB.

Advertisement

22nd October 2019, 08:06 #3
 Join Date
 Aug 2018
 Posts
 92
 Helped
 25 / 25
 Points
 711
 Level
 5
Re: Understanding of noise figure
Noise figure stands the ratio between the total noise above thermal noise. After LNA, both the signal and the noise level at the output has been significantly boosted, so the extra noise introduced by later stages becomes less significant.
+ Post New Thread
Please login