Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Use "Vector VN1610" and a serial terminal instead of "Vector CANoe"

Status
Not open for further replies.

ArakelTheDragon

Member level 3
Joined
Jul 9, 2017
Messages
58
Helped
8
Reputation
16
Reaction score
7
Trophy points
8
Location
If you like the post, please press "Like".
Activity points
350
Use "Vector VN1610" and a serial terminal instead of "Vector CANoe"

Hi guys,

I hope this is the correct place for my topic, if not please move it.

I am trying to get a serial terminal to work with "Vector VN1610" because I prefer to use it instead of "Vector CANoe", on "CANoe" everything works, but when I use the terminal I get "connected to device", however I receive no response or some random numbers which mean nothing to me. I use the following format:

REQUEST: CAN ID, DLC, Request(720 2 10 01)
Connection to the COM port is done at 9600kbps(active connection).

I think the problem may be in the "Vector hardware" which is responsible for assigning "Vector CANoe" to 1 of the 2 "CAN channels", but it does not show my software, I don't know why.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top