Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Phase current motor measurements with cro

Status
Not open for further replies.

vishjay

Member level 2
Joined
Feb 1, 2019
Messages
42
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
306
Hi,
How to measure phase current waveforms for delta connected motor using current probe with oscilloscope? How to connect the scope probes?

Thanks
 

If, and that is a big if, I am understanding you correctly:

You require three clamp type probes, a single differential high voltage probe, and a 4 channel scope.

Connect the high voltage probe to channel 1 and set the trigger to that channel.
Clamp the current probes to each phase and feed them to channels 2,3 and 4.

Make sure that all of the clamps are oriented correctly; i.e. that the arrow faces the motor.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top