Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ADC input with low pass RC filter

Status
Not open for further replies.

Adira.Neethi

Newbie level 1
Joined
Sep 4, 2019
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
11
I’m trying to implement 8 bit ADC in FPGA. FPGA running at 100MHz clock. PWM signal is given to RC filter. Knowing that f=1/2piRC, I have trouble with choosing the component's value. Is there any rule to find RC values and frequency?

I chose 100Mhz frequency, 7Kohm resistor and 10nF capacitor. I didn’t‘t get expected output. I used LVDS buffer of FPGA as comparator. Considering the LVDS behavior, How to find resistor value?
 

Hi,

We don´t know about your circuit.
We don´t know what kind of ADC you try to build.
We don´t know what cutoff frequency you like to have.

I chose 100Mhz frequency, 7Kohm resistor and 10nF capacitor.
No.
If you solve the above equation with "7kOhms" and "10nF" then the result "f" = 2.27kHz ... this is far away from 100MHz.
What do you try to achieve?

I didn’t‘t get expected output.
What output did you expect?

Klaus
 

You say ADC and then you mention PWM, which is DAC.
Which are you really trying to do?

It it's PWM DAC, what is the highest modulation frequency of the PWM?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top