Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

I want to get load signature for doing current analysis on my cells

Status
Not open for further replies.

nishil_bhavsar

Newbie level 1
Joined
Oct 9, 2019
Messages
0
Helped
0
Reputation
0
Reaction score
0
Trophy points
0
Activity points
8
For doing this, I am using a current sensor that gives me current data(ADC conversion time-532 μs) in continuous conversion mode over I2C(400kHz) and I am using a Raspberry Pi Zero-W to store this data locally. I want to connect the maximum number of sensors on one RPI Zero-W, using bit-banging on different RPI pins, I want to know what is the best method to do fetch data over I2C and store it when there are n current sensors for n cells at the maximum possible data rate.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top