Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Why should a solder joint be less than 110degc?

Status
Not open for further replies.
Apparently you didn't read the entire sentence...

Above that, there is a limitation for the component’s solder joint not to exceed 110 °C in continuous operation.

Soldering isn't operating.

The statement means the resistor film is in excess of 110C if the solder joints are at 110C.
 

Continous operation is the keyword I guess. Obviously it won't melt the solder paste, but device won't tolerate this operating (quasi ambient) temperature.
 

The way the Vishay word salad is packed, makes me think
this is about thin film resistivity stability and/or trim stability.
The criterion may not be failure but tolerance drift.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top