Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Altium "has only one pin" error - why?

Status
Not open for further replies.

MarkoSiroki

Member level 2
Joined
Feb 17, 2013
Messages
46
Helped
4
Reputation
8
Reaction score
4
Trophy points
1,288
Location
Ljubljana
Activity points
1,558
Dear Sirs and Madams!

I have following situation in Alitum:
altiumOnePinError.jpg
I am trying to connect AOUTR bus from repeated schematic to P3 and I get one pin​ errors. Why?
 

Without seeing the underlying schematic, audioinput.schdoc, it's impossible to tell.
 

On the top level AOUTR is a bus. On your schematic, it's a single signal.

Yes, on a top level it should be a bus, which is created from 8 same schematics (screenshot #2)'s signal AOUTR. And therefore is named AOUTR[1..8] or AOUTR[0..7].
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top