jimmykk
Full Member level 3
Hi
I have a silly question regarding Capture. I am making a rigid flex board where i have only a 20pin connector on rigid PCB and
the flex PCB will be having only these conductors coming from this 20 pin connector. These conductors end up with fingers which have to be
reflow soldered onto some other PCB. So was wondering,
Is that it in capture? I have an idea pcb designer has to be setup for flex board. But what else is needed in capture?
Thanks
I have a silly question regarding Capture. I am making a rigid flex board where i have only a 20pin connector on rigid PCB and
the flex PCB will be having only these conductors coming from this 20 pin connector. These conductors end up with fingers which have to be
reflow soldered onto some other PCB. So was wondering,
Is that it in capture? I have an idea pcb designer has to be setup for flex board. But what else is needed in capture?
Thanks