Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

OrCAD Capture rigid flex

Status
Not open for further replies.

jimmykk

Full Member level 3
Joined
Oct 2, 2014
Messages
158
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,298
Activity points
2,863
Hi
I have a silly question regarding Capture. I am making a rigid flex board where i have only a 20pin connector on rigid PCB and
the flex PCB will be having only these conductors coming from this 20 pin connector. These conductors end up with fingers which have to be
reflow soldered onto some other PCB. So was wondering,
caff.PNG
Is that it in capture? I have an idea pcb designer has to be setup for flex board. But what else is needed in capture?
Thanks
 

You'll need a connector on the left side as well. The flex/PCB footprint for the connector on the left will be the fingers.
 

Thanks for reply, but could not find any connector with that name.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top