Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Incisive Intallation using Installscape

Status
Not open for further replies.

Puppet123

Full Member level 6
Joined
Apr 26, 2017
Messages
356
Helped
22
Reputation
44
Reaction score
21
Trophy points
18
Activity points
3,058
Hello,

Want to install Incisive add on to Cadence DFII using Installscape on Centos 6.

Do I tell Installscape where DFII installation is already and then install Incisive ?

Does Incisive have to be installed before Cadence DFII or can it be installed after the Cadence installation ?

Any special considerations for Centos ? Will Incisive work on Centos ?

Thank you.
 

> Do I tell Installscape where DFII installation is already and then install Incisive ?

No, you can install anywhere you like. The installations are independent (-ish) of each other.

> Does Incisive have to be installed before Cadence DFII or can it be installed after the Cadence installation ?

No, you can install anywhere you like.

> Any special considerations for Centos ? Will Incisive work on Centos ?

It will work, but it is not a supported platform, thus if you bump into issues, you might have to solve them a bit creatively. Centos is quite similar to Redhat which would be your starting point.

https://www.cadence.com/content/dam...uments/support/supported-platforms-matrix.pdf
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top