+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Newbie level 3
    Points: 79, Level: 1

    Join Date
    Jun 2019
    Posts
    5
    Helped
    0 / 0
    Points
    79
    Level
    1

    How do i read or write to ram address given in datasheet? using verilog

    How can i read or write from ram addresses like 32bits @ Ox AAAA etc mentioned in datasheet...using verilog..thank you.

    •   AltAdvertisement

        
       

  2. #2
    Advanced Member level 5
    Points: 37,911, Level: 47
    Achievements:
    7 years registered

    Join Date
    Jun 2010
    Posts
    6,874
    Helped
    2019 / 2019
    Points
    37,911
    Level
    47

    Re: How do i read or write to ram address given in datasheet? using verilog

    Far far too vague.
    You need some code to control whatever the interface to provide the address and data.



    •   AltAdvertisement

        
       

  3. #3
    Advanced Member level 4
    Points: 8,521, Level: 22
    Achievements:
    7 years registered Created Blog entry
    dpaul's Avatar
    Join Date
    Jan 2008
    Location
    Germany
    Posts
    1,276
    Helped
    275 / 275
    Points
    8,521
    Level
    22
    Blog Entries
    1

    Re: How do i read or write to ram address given in datasheet? using verilog

    As mentioned above, you need to provide the bus info connecting the RAM.
    Then you need to drive those bus signals for READ or WRITE cases.
    FPGA enthusiast!



--[[ ]]--