Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How do i read or write to ram address given in datasheet? using verilog

Status
Not open for further replies.

crb

Newbie level 4
Joined
Jun 15, 2019
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
38
How can i read or write from ram addresses like 32bits @ Ox AAAA etc mentioned in datasheet...using verilog..thank you.
 

Far far too vague.
You need some code to control whatever the interface to provide the address and data.
 

As mentioned above, you need to provide the bus info connecting the RAM.
Then you need to drive those bus signals for READ or WRITE cases.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top