Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

100MHz - 1GHZ Bowtie Antenna

Status
Not open for further replies.

ateet101

Newbie level 6
Joined
Jun 8, 2015
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
98
Is there a way to design a flat bowtie antenna from 100MHz to 1GHz? When I design using CST, I can't cover the whole bandwidth no matter how big i make the antenna. The only way it covers more badwidth is if I go up in frequency. I'm just asking if it's possible.

I can probably buy a bicone, but every bicone for that frequecny range is very expensive

Thanks
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top