Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ConnectLib files in ams simulation Cadence

Status
Not open for further replies.

Chinmaye

Full Member level 3
Joined
Jan 18, 2016
Messages
164
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,298
Activity points
3,145
Hello all,
I am trying to perform a test AMS simulation. After ADE launch, we go to setup->Connect rules. There i see a set of standard rules like 18_full_fast, 5_full_fast etc. All of these have logic low of 0V and logic high of 5V/1.8V etc. My requirement is that I would like to have a logic low of -900mV and logic high of 900mV. Is there a way out?
 

Yes. You have to create your own level converter - if the AMS lib doesn't offer one.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top