Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Need help on ADS inductor simulation

Status
Not open for further replies.

jwonoh

Newbie level 5
Joined
Jul 31, 2019
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
98
Hi all

I have a problem with balun simulation which is made by coilsys.

as you can see bellow, 4 layout pins are connected to same net ( P_minus ) and I wanna force these pins to adequate nets respectively.

How can I force them ..?

qqqqq.PNG
 

But they are physically connected, you wanna separate the nets ?? I don't think so that is possible..
 

Is the layout correct? Is there a connection between primary and secondary, possibly because of wrong layer assigments?
 

This is not a Balun, it's a transformer with tapped pins.It can be used as a Balun of course but tapped pins are not necessary if you don't drive an active circuit through them..
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top