Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Analog-Digital Interface Bridge in SiMetrix

Status
Not open for further replies.

Adithya_Pai

Newbie level 6
Joined
Jun 20, 2019
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
151
I am curious to understand Analog-Digital Interface Bridge in SiMetrix which has model card with these parameters as mentioned in image

model.JPG

I am simulating this component with this test setup

Bridge-Interface.JPG

Simulation waveform

Bridge Interface plot.png

in_low=2.1
in_high=2.2

which can be understood as thresholds but looks like out_low, out_high, clamp_low, clamp_high needs some other test cases can anyone elaborate in these parameters in the model card of adc interface?

I will be sharing a link from SiMetrix of website which i had refered

https://help.simetrix.co.uk/8.0/simetrix/mergedProjects/simulator_reference/topics/simref_digitalmixedsignaldevicereference_analog_digitalinterfacebridge.htm#MiniTOCBookMark9
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top