Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Type one compensator...why is everybody giving it a phase of -90 degreees

Status
Not open for further replies.
T

treez

Guest
Surely a type one compensator phase vs frequency Bode plot should always be drawn with -270 degrees phase?
I mean, -180degrees for the inverting opamp...then -90 degrees for the capacitor in the feedback path...thats -270degrees...so why do most people say the phase is -90 degrees?..its non-intuitive.



-------------------------------000000------------------------------------
Same thing tfor the type 2 compensator on page 5 of this...
https://www.ti.com/lit/an/slva662/slva662.pdf

..surely the phase should start off at -270 degrees, not -90 degrees?
Starting it at -90 degrees ignores the -180 degrees contributed by the inverting opamp...the inversion gives the -180 degrees....why do all articles ignore it?
 
Last edited by a moderator:

Often the 180 contributed by the opamp is left out during analysis. It's then accounted for by calculating phase margin relative to -180 degrees, rather than -360.

So long as it's done consistently, it gives the same answers. Just a preference for some engineers.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Type I is just a single pole integrator. Poles are understood to introduce a 90 degree phase lag or -90 degree phase shift.

Other phase shifts can be seen as external.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top