Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] CD4053 connect unused pins

Status
Not open for further replies.

clros

Member level 2
Joined
May 26, 2018
Messages
45
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
387
Hi,
in a cd4053 I do not used some pins (input and output).

How should I connect them?
 

The analog switch terminals can be left floating without problems. Or connect them to ground.
 
  • Like
Reactions: clros

    clros

    Points: 2
    Helpful Answer Positive Rating
Hi,

Sadly you don't tell which pins these are...

Dedicated CMOS input pins (control pin) should not be left floating.

Klaus
 
  • Like
Reactions: clros

    clros

    Points: 2
    Helpful Answer Positive Rating
no input pin should be left unconnected - analog or digital

when I have the space, i like putting in a 0 ohm jumper to ground on a pin by pin basis
just in case, if i need an extra ???, its relatively easy to remove the jumper and put in a wire.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top