Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

M.2 ssd B&M key pcb design

Status
Not open for further replies.

Dushyant Kumar

Newbie level 5
Joined
Sep 19, 2014
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
60
hello,
I am designing the PCB in which I am using a lenovo Sl700 M.2 128G SSD B&M key.

This SSD has B&M key and is used as PCIE as well as SATA configuration. Pin out diagram of B Key shows that "Config_(0,1,2,3) should be grounded. so my question is, if I want to use PCIE what will be the status of Config pin?

you can check this link "https://pinoutguide.com/HD/M.2_NGFF_connector_pinout.shtml"

Thanks in advance.
Dushyant
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top