Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] MOSFET instead of planar resistors

Status
Not open for further replies.

Zak28

Advanced Member level 2
Joined
Aug 19, 2016
Messages
579
Helped
6
Reputation
12
Reaction score
6
Trophy points
18
Activity points
4,681
Is it fine to employ to220/247/3P MOSFETs as resistors inplace of similarly packaged planar resistors for constant loads and for switched loads?

The NMOS would be biased with a precision pot at its gate using a DMM from power supply to drain to make the current precise.

Constant load.

load.png


Switched load.

nmos-load.png
 
Last edited:

1. Don't expect stable current in this circuit due to temperature dependent Vgs/Id characteristic. Some kind of feedback suggested.
2. Consider reduced power rating of MOSFET in linear mode caused by inhomogeneous current distribution. Check SOA in datasheet.
 
  • Like
Reactions: Zak28

    Zak28

    Points: 2
    Helpful Answer Positive Rating
1. Don't expect stable current in this circuit due to temperature dependent Vgs/Id characteristic. Some kind of feedback suggested.
2. Consider reduced power rating of MOSFET in linear mode caused by inhomogeneous current distribution. Check SOA in datasheet.

What feedback arrangements are there without high speed opamps?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top