Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

curve fitting for input and output matching

Status
Not open for further replies.
C

circuitking

Full Member level 5
Joined
Jan 8, 2018
Messages
291
Helped
1
Reputation
2
Reaction score
1
Trophy points
18
Activity points
2,503
Hi, In this video (https://www.youtube.com/watch?v=3l6Xmtg558w) he says he used curve fitting for input matching. I came to know for broadband matching I should deal with impedance curves rather than points. Could anyone elaborate the idea of curve fitting for input and output matching and also how to synthesize the matching networks that fit the impedance curve or any detailed material?. Thanks
 
Last edited:

Use $table_model() in Verilog-A.

If you use Keysight ADSsim, use Data Access Component.
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top