Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] [moved] Routing signal like clock tree in Cadence Encounter

Status
Not open for further replies.

Abdo_Mgdy

Newbie level 6
Joined
Aug 27, 2019
Messages
12
Helped
2
Reputation
4
Reaction score
2
Trophy points
3
Activity points
76
I need to route scan_en signal as clock tree network in Cadence Encounter, so that it reaches all scan flops with minimum skew.
 

You sure you need this? Scan enable is not supposed to toggle like the clock, skew should not be an issue. Hold it high for a bit, submit all the test vectors you want while it is stable. No skew problem.
 

It doesn't toggle like clock, this is right .. but it's highly loaded, it's supposed to reach every flop in the design , so it need to be buffered such like clock tree
 

It doesn't toggle like clock, this is right .. but it's highly loaded, it's supposed to reach every flop in the design , so it need to be buffered such like clock tree

buffering is easy, the tools will take care of it automatically. you don't need to do anything special.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top