Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to fix Coax Cable of Vector Network Analyzer?

Status
Not open for further replies.

swadesh07

Junior Member level 3
Joined
Jun 14, 2011
Messages
31
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,530
Hello,

We have Vector network analyzer that goes from 10MHz to 67GHz. For last couple of weeks, one of the coaxial cable is fluctuating a lot. As we know a new coax cable at this frequency is very very costly. So I was wondering is there any way to find the problem, root cause and any procedure to fix that cable. Thanks in advance.

Regards
Swadesh
 

If the cable is broken down, all you have to do is to replace with a new one.Coaxial cable are not repaired especially measurement grade ones..
The problem may come from the connector junction, have you ever checked it out ?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top