Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Hspice DC simulation result is unusual and error.

Status
Not open for further replies.

dressler6

Newbie level 6
Joined
May 22, 2019
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
144
Hspice DC simulation result is unusual and error.

The input is shown below, and the output is shown in the figure.
Do you know the cause and solution?

Sandwork version is 2013.03-SP1,
Hspice version is Hspice_L-2016.06-SP2.

Thanks in advance.

Code:
******** Input ***************************
.param pvdd      = 3

ven		en		0	3

.options post scale=1 MEASDGT=5
.option node
.op

.dc pvdd 0 3.8 0.01

.probe v(*) i(*) v(*.*) i(*.*)

.end

z3.jpg
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top