+ Post New Thread
Results 1 to 5 of 5

16th August 2019, 20:47 #1
 Join Date
 Aug 2019
 Posts
 2
 Helped
 0 / 0
 Points
 20
 Level
 1
dc motor theory question??? Maths
Hello,
I have a few questions which I cannot be sure I'm calculating right.
Here is what I have:
Motor speed 500rpm
Back emf 115v
Supply voltage 200v
Motor torque 40nm
I have to work out..
Armature current drawn
Armature resistance
Shaft power
What would be the rpm if the torque increased to 60nm
I have calculated
18.21amp
275.57mOhms
2.8HP
And by ratio 333rpm as I do not have flux.
All assuming 100 percent efficiency.
Can anyone find fault with my answers??

Advertisement

17th August 2019, 08:12 #2
 Join Date
 Nov 2012
 Posts
 3,148
 Helped
 777 / 777
 Points
 17,223
 Level
 31
Re: dc motor theory question??? Maths
I really do not know where to start.
But you have calculated somehow; tell us the steps.
Once we know the steps we can comment.
How to convert the motor torque 40nm to watts?
Is it a DC motor with 200v DC working voltage)? Anatomically, all motors are AC because of commutation is needed for DC but that is a different story anyway.
Do you assume that the load presented by the rotor is zero?
Shaft power should be the same as the motor power because we have no idea about the losses (both copper and iron losses).

Advertisement

17th August 2019, 22:01 #3
 Join Date
 Nov 2009
 Location
 Italy
 Posts
 1,125
 Helped
 386 / 386
 Points
 8,330
 Level
 21
Re: dc motor theory question??? Maths
Last edited by albbg; 17th August 2019 at 22:15.

Advertisement

18th August 2019, 05:05 #4
 Join Date
 Aug 2019
 Posts
 2
 Helped
 0 / 0
 Points
 20
 Level
 1
Re: dc motor theory question??? Maths
Ia =( wt)÷eb (52.4x40)÷115 = 18.2amp

5th September 2019, 06:55 #5
 Join Date
 Sep 2019
 Posts
 48
 Helped
 1 / 1
 Points
 210
 Level
 2
Re: dc motor theory question??? Maths
I know how to DC motor calcs, no problems there, but first some questions. Where did you get the data that you "have"? Is this your measured data from a real motor? How did you measure the back emf?
Or is this a hypothetical question that you have been given as an engineering assignment or similar?
+ Post New Thread
Please login