Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Reset problem in ds pic33ep512mu810

Status
Not open for further replies.

raman00084

Full Member level 6
Joined
Nov 29, 2010
Messages
360
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
3,995
I am using dspic 33ep512mu810 to control 2 ac servo drive. Every thing works good. Some times if i press reset button the controller stops the job but hangs i have to press the reset button 2 to 3 times to reset again, this happens arount 1 in 4 to 5 resets. Kindly give solution COMPLIER USED PIC CCS
 

The problem is clearly in line 234, near the function for grinding smoke.

If you want a sensible answer you will have to give us more information, we have absolutely no idea of your hardware design or the software so asking for where the problem lies is pointless.

Brian.
 

The problem is clearly in line 234, near the function for grinding smoke.
That's probably the line where they check the reset input but didn't debounce the signal properly, so the program calls fCrashAndBurn() instead of fGrindingSmoke.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top