+ Post New Thread
Results 1 to 4 of 4
  1. #1
    Full Member level 1
    Points: 1,117, Level: 7

    Join Date
    Dec 2015
    Posts
    100
    Helped
    9 / 9
    Points
    1,117
    Level
    7

    How to add the outputs of a different voltage double ciruits

    hello everyone,

    can you please help me to add the outputs of two voltage doubler circuits shown in the following figure.


    Click image for larger version. 

Name:	REctifier.png 
Views:	18 
Size:	29.9 KB 
ID:	154966

    •   AltAdvertisement

        
       

  2. #2
    Super Moderator
    Points: 52,584, Level: 56

    Join Date
    Apr 2011
    Location
    Minneapolis, Minnesota, USA
    Posts
    12,875
    Helped
    2568 / 2568
    Points
    52,584
    Level
    56

    Re: How to add the outputs of a different voltage double ciruits

    Rework one circuit so it outputs negative polarity. Connect your load across the two outputs. This method works if the two ground icons represent a single ground.

    Or, the output stages can be connected similar to two batteries in series. This method works if the two circuits have separate grounds.


    1 members found this post helpful.

    •   AltAdvertisement

        
       

  3. #3
    Super Moderator
    Points: 77,026, Level: 67
    Achievements:
    7 years registered
    Awards:
    Most Frequent Poster 3rd Helpful Member

    Join Date
    Apr 2014
    Posts
    15,607
    Helped
    3556 / 3556
    Points
    77,026
    Level
    67

    Re: How to add the outputs of a different voltage double ciruits

    Hi,

    Omit the upper GND (symbol).
    Connect the lower end of R1 with the upper end of R1.

    Klaus
    Please don´t contact me via PM, because there is no time to respond to them. No friend requests. Thank you.


    1 members found this post helpful.

    •   AltAdvertisement

        
       

  4. #4
    Full Member level 1
    Points: 1,117, Level: 7

    Join Date
    Dec 2015
    Posts
    100
    Helped
    9 / 9
    Points
    1,117
    Level
    7

    Re: How to add the outputs of a different voltage double ciruits

    Quote Originally Posted by KlausST View Post
    Hi,

    Omit the upper GND (symbol).
    Connect the lower end of R1 with the upper end of R1.

    Klaus
    Thank you sir, it worked out. can you please explain further on removing upper GND (symbol)...



--[[ ]]--