Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

IC Touch and nrf24L01

Status
Not open for further replies.

bravehamid

Junior Member level 1
Joined
May 26, 2015
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
101
Capacitive Effect on Tracks

Hello good time
I designed a board that has a Micro 328 , Has 3 touch channels, and works fine, but when i put nrf on board, two of the channels don't work, and it crashes.
But when I remove the nrf from the board and reset the micro, the circuit breaks again (I opened the nrf on the board and wired it to the board, but it didn't work again)
What do you think it could be? I was confused whether it could be a capacitive effect or something else.
 

Hello
I designed a board that has a Micro 328 , Has 3 touch channels, and works fine, but when i put nrf on board, two of the channels don't work, and it crashes.
But when I remove the nrf from the board and reset the micro, the circuit breaks again (I opened the nrf on the board and wired it to the board, but it didn't work again)
What do you think it could be? I was confused whether it could be a capacitive effect or something else.
 
Last edited by a moderator:

Hi,

EMI, EMC. Bad PCB Layout.
Use one layer as GND plane. Use decoupling capacitors. Use HF filters.

Klaus
 

Re: Capacitive Effect on Tracks

What on earth is an “nrf”?? National Retail Federation?

When you post a question here don’t assume everyone knows your arcane abbreviations.
 

Re: Capacitive Effect on Tracks

Of course you are right.
nRF24L01 Wireless Module
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top